Lambo Door Installation Tech Tips
1. Do not take the doors off during installation. Please follow the detailed instruction manual step by step.
2. Make sure the mounting surface is as flat as possible.
3. Make sure both allen screws adjustments on each system are adjusted accordingly.
4. The kit requires no modification. The kit is a bolt-on, but most inner fenders must be rolled.
For Tech Support, please contact our tech support department M-F 8:30 AM – 4:30 PM (Pacific Standard Time). Before you call, please have all questions ready to ask. We are more than happy to answer any technical problems.
Adjust the Door Striker and Lock it in place
Make sure to adjust the striker properly and to lock it in place after the installation, if the locking nut is not locked in place the bolt will come loose and the door will fall out of adjustment.
The striker should look like the image below and the sound of the door should be very close to the original sound it makes with the factory door hinges.
If the door is too HIGH
You will have to lower the door by turning the adjustment screw counter-clockwise until the stricker is aligned just like the image below
If the door is too LOW
You will have to raise the door by turning the adjustment screw clockwise until the stricker is aligned just like the image below.
Lock the door in place
After adjusting the door striker, make sure to lock the locking nut into place to avoid the adjustment screw from becoming loose like image below.
Shock
Please Note: You cannot compress the shocks by hand. The shock has 450 lbs – 800 lbs of pressure per square inch. They will not compress until installed on the hinge.
How to Install a Vertical Doors’s shock
Marking the factory door location
Note: This is one of the most important parts of the installation.
During the Vertical Doors, Inc. installation, you will need to remove the factory door hinges.
Before removing the factory hinges you MUST mark the factory location of the door on the vertical and horizontal planes.
Also, mark and measure the distance between the apron and the edge of the door by the top and bottom hinge.
After making sure you have all the necessary marks in case the door moves during installation, you can remove the factory door hinges.
Horizontal Movement Adjustments
How to adjust the horizontal movement of the Door Conversion Hinge
How to install on Chrysler 300 C
Corvette C8 Fender Removal
Installation on a Chevrolet Corvette C5 1997-2004
Chevrolet Corvette C5 1997-2004 Lambo Door Kit Installation Part 1
Chevrolet Corvette C5 1997-2004 Lambo Door Kit Installation Part 2
Installation on a Hyundai Genesis Coupe 2009 – 2015
Hyundai Genesis Coupe Lambo Door Installation Part 1
Hyundai Genesis Coupe Lambo Door Installation Part 2
Installation of the Rear Lambo doors on a Dodge Charger
All Tech Tips and images on this site and/or in the Printed instructions are for reference only. Your vehicle may be different and they may not apply to your vehicle. Vertical Doors Inc. assumes no responsibility for any damages caused by improper installation.
